1. go to Settings → WLS service (Fig. 1.1);
   
   Figure 1 – WLS service form
    

2. specify the address of the repository WSL service (Fig. 1.2), depending on the type of cryptography:

   The 443 port must be open.

   1. 1. https://rsa.nsd.ru/onyxpl/WslService – RSA, PL (test environment);
      2. https://gost.nsd.ru/onyxpl/WslService – GOST, PL (test environment);
      3. https://edor.nsd.ru/onyxpr/WslService – RSA, PROM (production environment);
      4. https://edog.nsd.ru/onyxpr/WslService – GOST, PROM (production environment);
      5. https://rsa-g.nsd.ru/onyxgs/WslService – RSA, GUEST (test environment);
      6. https://gost-g.nsd.ru/onyxgs/WslService – GOST, GUEST (test environment).
3. select the WSL service connction mode (Fig. 1.3):
   1. automatic mode selection (recommended);
   2. standard HTTPS (with RSA cryptography support);
   3. native HTTPS (with GOST cryptography support).

To apply the settings, click Save (Fig. 1.4).

Configuring in svc.config

To navigate to the file svc.config you need to paste %LOCALAPPDATA% into the Windows Explorer and press Enter on the keyboard,then go to the installation folder NSD.FileGateway.

 To configure the connection with the the WSL- service of the repository, you must change the required parameters in the svc.config XML file. Valid options are presented in table 1.

Table 1 – File Gateway Setup Parameters